TM 5-3805-262-34REMOVAL (SHEET 3 OF 3)(5)(6)(7)(8)(9)(10)Using electrical tape, tape cab upper wiring harness three wiper motorwires disconnected in step (4) above to a 16 feet long piece of wire.This wire-will be used as a fish wire to fish new wiring harness throughleft front and rear posts.At cab ceiling, pull cab upper wiring harness branch containing threewiper motor wires slowly upward while assistant guides wires through holein left post.At left rear of cab, just behind heater console, disconnect cab consolewiring harness connector from cab upper wiring harness connector. Do thisby disengaging cab console wiring harness connector tabs from ears ofupper cab wiring harness connector using a screwdriver. Grasp connector”body and firmly pull from mating connector.Reach down into space between cab outer and inner walls and push cabupper wiring harness connector into cab. Do this by pressing on rear ofconnector using your fingers forcing it into cab.Slowly pull connector and wiring harness down through left rear postwhile an assistant guides harness wires. Be careful not to lose fish wiretaped to harness three wiper motor wires.Remove electrical tape from cab upper wiring harness three wiper motorwires. Discard cab upper wiring harness. Don’t remove fish wire. It willbe used to install new cab upper wiring harness.3-299
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business