TM 5-3805-262-343-7. TRANSMISSION MAINTENANCE (CONT)b. TransmissionMounts.This task covers removal and installation of transmis-sion mounts.TOOLS: No. 1 Common Organizational Maintenance Tool KitTorque wrench, 1/2 inch driveAutomotive Mechanic-s Tool KitSocket wrench set, 1/2 inch driveHydraulic pressRod, 1-7/8 inches diameterSleeve, 3 inches inside diameterTransmission jackMATERIALS/PARTS: Detergent (Appendix C, item 4)Rubber mounts (FSCM 76005 PN J6198-9)Lock nuts, two (FSCM 96906 PNPERSONNEL REQUIRED: Two Construction EquipmentREFERENCE: TM 5-3805-262-20NOTEMS51922-57)Mechanics MOS 62BPRELIMINARY PROCEDURE: Engine front side panels removed and parkingbrake chamber removed (refer to TM 5-3805-262-20).REMOVALNOTERemove then install one transmission mount at a time to prevent stress-ing transmission and engine.(1)Install transmission jack under transmission and take up all weight oftransmission.(2) While assistant holds capscrew (6) at right side bracket (8) using socketwrench, remove lock nut (1) and washer (2).(3) Remove four capscrews (3 and 4) and lock washers (5) from right sidebracket (8). If necessary, raise transmission using transmission jack.(4) Remove capscrew (6) and washer (7).(5) Remove right side bracket (8)with rubber mount (9).(6) Put right side bracket (8) inhydraulic press. Using hydraulicpress and 1-7/8 inches diameterrod, press rubberbracket as shown.mount.NOTEmount (9) fromDiscard rubberRepeat above to remove left sidetransmission mount.3-324
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business
