OIL FLOW OUT OF TRANSMISSION CHECK (SHEET 2 OF 2)

OIL FLOW OUT OF TRANSMISSION CHECK (SHEET 1 OF 2)

TM-5-3805-262-34 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
462

OIL FLOW OUT OF TRANSMISSION CHECK (5) (6) (7) (8) (9) (lo) (11) (12) (13) (14) (15) Open flowmeter PRESSURE TM 5-3805-262-34 (SHEET 2 OF 2) VALVE completely. Set flowmeter ON position. Set flowmeter ON-OFF switch to FLOW switch to FLOW position. Set flowmeter RANGE switch to HI position. Start engine and operate at idle speed. If CONV TEMP gage pointer is not approximately 1/2 inch from bottom of gage, go to step (10) below other- wise go to step (14) below. Be sure parking brake valve knob is pushed in. Press brake treadle and valve and move transmission control lever to H position. Increase engine speed to full throttle and hold for 30 seconds. Set transmission control lever to N position and operate engine at idle speed for ten seconds. Repeat steps (10) through (12) above until CONV TEMP gage needle is ap- proximately 1/2 inch from bottom of gage. Increase engine speed to 2000 rpm. Be sure transmission control lever is in N position. Flowmeter should indicate at least 18.5 gallons per min- ute. If flow is less than 18.5 gallons per minute, charging pump is worn or there is internal leakage in the transmission. Replace charging pump (page 3-344) and repeat this check. If flow is still less than 18.5 gal- lons per minute, replace transmission (page 3-328). Turn off engine and disconnect flowmeter. Reconnect oil cooler hose dis- connected above to fitting installed in transmission. 3-323

Privacy Statement
Press Release
Contact