TM 5-3805-262-34
3-7. TRANSMISSION MAINTENANCE (CONT)
b. Transmission Mounts (Cont).
INSTALLATION
(1)
(2)
(3)
(4)
(5)
(6)
(7)
Lubricate new rubber mount (9) using soap
and water solution or liquid detergent.
Put rubber mount in hydraulic press. Posi-
tion right side bracket (8) on top of
rubber mount. Using hydraulic press and 3
inches inside diameter sleeve, press
rubber mount through hole in right side
bracket as shown.
Position right side bracket (8) at
right side of transmission.
Install washer (7) and capscrew
(6) through steel inner member of
rubber mount (9).
Install four lock washers (5), capscrew (4) and three capscrews (3). Two
inches long capscrew (4) is installed in top front mounting hole. Tighten
capscrews to 135 to 165 lb-ft.
Install washer (2) and new lock nut (1) on capscrew (6). Tighten lock nut
to 135 to 165 lb-ft.
NOTE
Repeat above to install left side transmission mount.
Lower transmission jack and remove from beneath transmission.
Install parking brake chamber on welded extension of left side bracket
(10) and adjust linkage (refer to TM 5-3805-262-20).
3-326
