INSTALLATION (SHEET 1 OF 3) - TM-5-3805-262-34

c. Transmission Replacement (Cont) - TM-5-3805-262-34_489

TM-5-3805-262-34 Loader Scoop Type DED 4x4 Articulated Frame Steer 2-1/2 Cubic Yard (J.I. Case Model MW24C) Manual
Page Navigation
475

TM 5-3805-262-34 3-7. TRANSMISSION MAINTENANCE (CONT) c. Transmission Replacement (Cont). (2) Detailed Procedure (Cont). INSTALLATION (SHEET 1 OF 3) When using chain hoist to remove or install parts, be sure chain hoist is securely fastened to part and that all slack in chain is taken up. Failure to do so could cause serious injury due to part falling on you. If you are injured by falling equipment, obtain medical aid immediately. Check that all hoses, lines, and electrical leads are clear as transmission is lowered into loader. If necessary, reposition hoses, lines, or electrical leads before installing transmission. NOTE If rubber mounts (9 and 11) 3-324) before proceeding. (a) Put transmission left side bracket (10) in position on chassis. Install and tighten washer (7), capscrew (6), washer (2), and new lock nut (1). (b) Connect chain hoists to transmission front and rear. Raise transmission from ground and put in position over loader rear chassis. Slowly lower transmission into loader. Then connect transmission jack to bottom of transmission and remove front chain hoist. are damaged or deteriorated, replace (page 3-336

Privacy Statement
Press Release
Contact