TM 5-3805-262-34
3-7. TRANSMISSION MAINTENANCE (CONT)
d. Control Valve.
This task covers removal and installation of control valve.
TOOLS: No. 1 Common Organizational Maintenance Tool Kit
Torque wrench, 1/2 inch drive
Automotive Mechanic's Tool Kit
Socket wrench set, 1/2 inch drive
Putty knife
Rubber mallet
MATERIALS/PARTS: Clean cloths (Appendix C, item 1)
Cleaning solvent P-D-680 (Appendix C, item 2)
Grease (Appendix C, item 7)
Lubricating oil (Appendix C, item 15)
Transmission gasket kit (FSCM 73342 PN 6838897)
REFERENCES: TM 5-3805-262-10
TM 5-3805-262-20
NOTE
PRELIMINARY PROCEDURE: Engine right front side panel removed (refer to
TM 5-3805-262-10), transmission oil drained, back-up alarm switch
removed, neutral start switch removed, clutch pressure switch removed,
control valve linkage disconnected from control valve spool, and clutch
cutout cylinder removed (refer to TM 5-3805-262-20).
REMOVAL
(1) Remove capscrew (1) and one lock washer (2).
(2)
Support control valve (4) and
and retaining bracket (6) (if
(3) Using rubber mallet, hit con-
trol valve to loosen control
valve from transmission
housing. Remove control valve
(4) and gasket (5). Discard
gasket (5).
remove 15 capscrews (3), lock washers (2),
used) .
3-341
