TM 5-3805-262-343-8.DRIVESHAFTSMAINTENANCE(CONT)c. CenterSupportBearing.This task provides disassembly, cleaning, inspection,repair, and reassembly of center support bearing.TOOLS: No. 1 Common Organizational Maintenance Tool KitSafety glassesFixed open end wrench setKey set, socket head screwViseRubber malletMATERIALS/PARTS: Clean cloths (Appendix C, item 1)Cleaning solvent P-D-680 (Appendix C, item 2)Grease (Appendix C, item 7)REFERENCES: TM 5-3805-262-20LO 5-3805-262-12NOTEPRELIMINARY PROCEDURE: Center support bearing removed (refer to TM5-3805-262-20).DISASSEMBLY(1)(2)(3)(4)(5)(6)If necessary, loosen setscrews (1 and 2) and remove.Remove lubrication fitting (3).Turn center support bearing upside down and let lock pin (4) fall out oflubrication fitting (3) bore into your hand.Put center support bearing housin(6) in a vise. Using rubber mallet,hit bottom of bearing and seal (5)to turn bearing in housing as shown.Continue hitting bearing and seal (5) until bearing is alined withnotches in housing (6).Remove bearing and seal (5) from housing (6).3-352
Integrated Publishing, Inc. - A (SDVOSB) Service Disabled Veteran Owned Small Business