TM 5-3805-262-34
REASSEMBLY (SHET 2 OF 2)
(7)
(8)
(9)
(10)
Hold cylinder (6), piston
(5), and spring (3) in po-
sition and install 5/8 inch
inside diameter washer and
3/4 NC nut on shaft of
piston (5) as shown.
Tighten 3/4 NC nut to compress
spring (3). Make sure match
marks are alined.
Remove brake chamber from vise.
Position warning plate (8) on
brake chamber and install eight
capscrews (7). Tighten cap-
screws evenly.
(11) Remove 3/4 NC nut, 5/8 inch inside diameter washer, and chamber tool from
brake chamber.
(12) Install nut (2) on shaft of piston (5).
(13) Install yoke (1) on shaft of piston (5).
(14) Adjust yoke (1) to measurement recorded at disassembly.
(15) Hold yoke (1) and tighten nut (2).
(16) Install parking brake chamber (refer to TM 5-3805-262-20).
3-419
