TM 5-3805-262-34
3-15. AUXILIARY STEERING PUMP AND MOTOR MAINTENANCE (CONT)
b. Removal, Separation, Joining, and Installation (Cont).
INSTALLATION
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
LEGEND
Position and support auxiliary steering pump and motor (4) at front left
side of rear chassis.
Install and tighten three capscrews (1), lock washers (3), and nuts (2)
to secure pump and motor (4). Then, position remaining capscrew (1) on
ground cable and install capscrew, lock washer (3) and nut (2) in mount-
ing hole noted in step (1) of removal above.
Connect electrical wires and cables and hoses, lines, and fittings to
auxiliary steering motor and pump (refer to TM 5-3805-262-20).
Connect battery ground cable (refer to TM 5-3805-262-20).
Start and operate engine at idle speed for two minutes.
Increase engine speed to full throttle for two minutes.
Pull SHUT OFF control out to stop engine. Leave ignition key switch in on
position.
Check that steering wheel turns fully left and right easily indicating
that auxiliary steering pump and motor is operating.
Check for hydraulic oil leakage at auxiliary steering pump and motor (4).
Set ignition key switch to off position.
4
1. Capscrews (4)
2. Nuts (4)
3. Lock washers (4)
4. Auxiliary steering
pump and motor
GROUND
CABLE
3-534
