TM 5-3805-262-34
3-15. AUXILIARY STEERING PUMP AND MOTOR MAINTENANCE (CONT)
d. Auxiliary Steering Motor (Cont).
REASSEMBLY (SHEET 4 OF 4)
(22)
(23)
(24)
(25)
(26)
(27)
(28)
(29)
(30)
(31)
LEGEND
1. Nut
Install new expansion plug (36) in
commutator end cover (37) with round
side of expansion plug toward out-
side. Using hammer and punch, bend
expansion plug to hold it in place.
Lift up brush springs (29) and
push brush set (28) brushes
against commutator. Lower brush
springs until they are on top of
brush set (28) brushes and hold-
ing brushes against commutator.
Install cover band (24) and secure with screw (22) and nut (23). Tighten
screw and nut securely.
Install two washers (13), four lock washers (12), and nuts (11) on
solenoid (14) studs.
Install two washers (10), three lock washers (9), and nuts (8) on
solenoid (14) studs.
Position strap (7) on solenoid (14) stud.
Install lock washer (6) and nut (5) to secure strap (7) to solenoid (14).
Position solenoid (14) and strap (7) on motor.
Install and tighten
Install and tighten
2. Lock washer
3. Screws (2)
4. Lock washers (2)
5. Nut
6. Lock washer
7. Strap
8. Nuts (3)
9. Lock washers (3)
10. Washers (2)
11. Nuts (4)
12. Lock washers (4)
13. Washers (2)
14. Solenoid
two lock washers (4) and screws (3).
lock washer (2) and nut (1).
3-556