TM 5-3805-262-34
REASSEMBLY (SHEET 1 OF 3)
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
1.
Install new bushing (13) in gland (14).
Install new seal (10) in gland (14).
Install new seal (11) in gland (14),
lips toward small end of gland.
Install wiper (12) in gland (14), lips
toward large end of gland.
Install backup ring (9) on gland (14).
If backup ring is not flat on both
sides, position side that is not flat at
small end of gland.
Install new O-ring (8) in gland (14) groove, next to backup ring (9) and
toward small end of gland.
Put rod (15) eye in vise and
support stand under rod near end
of rod. Put cloths between rod
and support stand to prevent
damaging rod.
Put clean lubricating oil on rod
(15), seals (10 and 11), wiper
(12), bushing (13), and bore of
gland (14).
Install gland (14) on rod (15)
using rubber mallet if necessary.
Separate new packing assemblies
(6). Put clean lubricating oil on
all parts of new packing
assemblies.
Install parts of one packing assembly (6) on smaller bore piston (5) as
shown.
Install parts of other packing assembly (6) on larger bore piston (4) as
shown.
3-741
