TM 5-3805-290-10
TILT (RETURN TO WORK) KICKOUT ADJUSTMENT - CONTINUED
0018 00
ADJUSTMENT - CONTINUED
WARN I N G
DO NOT perform adjustment with loader arm raised. Failure to follow this warning may cause injury or
death to personnel or damage to equipment.
N OT E
DO NOT adjust tilt (return to work) kickout angle by adjusting tube assembly.
7.
Loosen bolt and move switch assembly up or down
tube.
a.
If increasing tilt (return to work) kickout angle,
move switch assembly down tube assembly.
b.
If decreasing tilt (return to work) kickout angle,
move switch assembly up tube assembly.
8.
Tighten bolt to secure switch assembly.
427-B0581
9.
Test adjustment as follows:
a.
Start engine (WP 0005 00).
b.
Raise work tool (WP 0004 00) until lift arm is parallel to ground.
c.
Move work tool to full DUMP position.
d.
Move loader control joystick to TILT KICKBACK detent position (WP 0004 00).
e.
When work tool reaches preset tilt (return to work) kickout angle, joystick should return to HOLD position (WP
0004 00). Work tool will stop moving.
f.
Repeat steps 5 thru 9 until adjustment is correct.
g.
Lower work tool to ground.
h.
Shut down engine (WP 0005 00).
END OF WORK PACKAGE
0018 00-2