TM 5-3805-290-23-1
TROUBLESHOOTING SYMPTOM INDEX - CONTINUED
0007 00
TROUBLESHOOTING WITH AN EVENT CODE - CONTINUED
Table 3. Event Codes - Continued.
TROUBLE-
SHOOTING
EVENT
FAULT
FAULT
PROCEDURE
CODE
DESCRIPTION
CONDITIONS/EFFECTS
PAGE
E054
High Fuel Temperature
This code is generated when engine has been running for at least
Derate.
three seconds and fuel temperature is above trip point for machine
application. When this code is generated, warning lamp will flash
while "Derate" is active. ET will display "Engine Derate" in first
engine status box on any ET status screen. ECM will generate an
EID E054 event code on CAT data link. Event code will be
displayed on a ET diagnostic screen. A factory password is required
to clear the event code. Contact your local Caterpillar dealer to clear
this event code.
E100
Low Engine Oil
This code is generated when ECM detects that engine has been
Pressure Warning.
running for at least five seconds, engine speed is at least 350 rpm,
engine oil pressure is lower than threshold for low oil pressure for
more than two seconds, and these codes are not active:
100-03 Engine oil pressure open/short to +batt.
100-04 Engine oil pressure short to ground.
100-10 Engine oil pressure sensor abnormal rate
of change.
When this code is generated, ECM will log event and will reset
warning when oil pressure rises 3 psi (21 kPa) above threshold for
at least four seconds. This code has no effect on performance. A
factory password is required to clear the event code. Contact your
local Caterpillar dealer to clear this event code.
E190
Engine Overspeed
This code is generated when engine speed is above 3,000 rpm for
Warning.
3,054E for more than six seconds or engine speed is above 3,300
rpm for 3056E for more than six seconds. Reset point is 2,800 rpm.
This event indicates excessive engine speed. It does not represent
an electronic system fault with ECM or speed/timing sensor. When
this code is generated, event is logged in memory. This code has no
effect on performance. A factory password is required to clear the
event code. Contact your local Caterpillar dealer to clear this event
code.
E265
User Defined
This code is generated when ECM detects user-defined shutdown
Shutdown.
switch has been activated for one second, parking brake is set, and
machine speed is zero.When this code is generated, ECM will log
event and engine will shut down.
0007 00-28