TM 5-3805-290-23-1
TROUBLESHOOTING SYMPTOM INDEX - CONTINUED
0007 00
TROUBLESHOOTING WITH AN EVENT CODE
Table 3. Event Codes.
TROUBLE-
SHOOTING
EVENT
FAULT
FAULT
PROCEDURE
CODE
DESCRIPTION
CONDITIONS/EFFECTS
PAGE
E015
High Engine Coolant
This code is generated when engine has been running for at least
Temperature Derate.
three minutes, engine coolant temperature has exceeded trip point,
and delay time has expired. Alarm output will activate and event is
logged. When this code is generated, engine power is reduced. A
factory password is required to clear the event code. Contact your
local Caterpillar dealer to clear this event code.
E016
High Engine Coolant
This code is generated when engine has been running for at least
Temperature Shutdown.
three minutes, engine coolant temperature has exceeded trip point,
and delay time has expired. If engine shutdown is ENABLED fuel
will be shut off. Event is logged. When this code is generated,
engine is shut down. A factory password is required to clear the
event code. Contact your local Caterpillar dealer to clear this event
code.
E017
High Engine Coolant
This code is generated when engine has been running for at least
Temperature Warning.
three minutes, engine coolant temperature has exceeded trip point
of 230F (110C), delay time of four seconds has expired, and no
other codes for engine coolant are active. Alarm output will
activated and code is logged. When this code is generated, engine
operation is not immediately affected. However, if coolant
temperature continues to rise, engine will be derated. A factory
password is required to clear the event code. Contact your local
Caterpillar dealer to clear this event code.
E023
High Hydraulic Oil
This code is generated when ECM detects hydraulic oil temperature
Temperature Derate.
greater than 211F (105C) and hydraulic oil temperature is greater
than set point for four seconds or more. ECM will log event. ECM
will derate engine. At maximum derate, ECM will reduce fuel by
50 percent. Derate will become inactive after hydraulic temperature
returns below 208F (98C). When this code is generated, a low
power condition may also be present.
E025
High Inlet Air
This code is generated when engine has been running for at least
Temperature Derate.
three minutes, inlet air temperature has exceeded set point, delay
time has expired, and no other codes for inlet air temperature are
active. Alarm output will activate and event is logged.When this
code is generated, engine power is reduced. A factory password is
required to clear the event code. Contact your local Caterpillar
dealer to clear this event code.
0007 00-26
