TM 5-3805-290-23-1
TROUBLESHOOTING SYMPTOM INDEX - CONTINUED
0007 00
TROUBLESHOOTING WITH AN EVENT CODE - CONTINUED
Table 3. Event Codes - Continued.
TROUBLE-
SHOOTING
EVENT
FAULT
FAULT
PROCEDURE
CODE
DESCRIPTION
CONDITIONS/EFFECTS
PAGE
E272
Inlet Air Restriction
This code is generated when ECM detects inlet air restriction is
Warning.
greater than set point for four seconds or more. When this code is
generated, ECM will log event, ECM will transmit a warning to
display in cab, and machine will have low power.
E283
Low Hydraulic Charge
This code is generated when ECM detects a low hydraulic charge
Pressure.
pressure. This is not an electronic problem. Event code is logged.
Event code is active when hydraulic charge pressure becomes low.
When this code is generated, engine operation will not be affected.
However, if hydraulic charge pressure remains low, there may be a
problem with hydraulic system.
E441
Idle Elevated to
This code is generated when battery voltage has exceeded trip point
of 24.5V. When this code is generated, ECM will log event and
Increase Battery
increase engine speed. Actual increase will be between 1,000 and
Voltage.
1,100 rpm. This event indicates low battery voltage.
This code is generated when, engine shutdown was slow when
E442
Engine Failed to Stop
engine start switch was turned to OFF position, engine failed to shut
With a No-Fuel
Command.
down when engine start switch was turned to OFF position, or
engine failed to shut down when fuel injection pump stopped fuel
injection.When this code is generated, if engine still fails to shut
down, ECM will disable power relay for fuel injection pump. Event
code is logged in ECM memory.
E600
High Hydraulic Oil
This code is generated when ECM detects hydraulic oil temperature
Temperature Warning.
is greater than 223F (106C) and hydraulic oil temperature is
greater than set point for four seconds or more. ECM will log
warning and transmit a warning to display in cab. ECM will reset
warning when hydraulic oil temperature falls below 219F (104C)
for four seconds. When this code is generated, machine will have
low power.
E883
Engine Failed to Stop
This code is generated when engine shutdown was slow when
engine start switch was turned to OFF position, engine failed to stop
When Fuel Solenoid
when ECM disabled fuel injection pump, or engine failed to shut
Disengaged.
down when engine start switch was turned to OFF position. When
this code is generated, ECM attempts to shut down engine by
instructing fuel injection pump to stop fuel injection. Event code is
logged in ECM memory.
END OF WORK PACKAGE
0007 00-29/(0007 00-30 Blank)
