TM 5-3805-290-23-1
TROUBLESHOOTING WITHOUT A DIAGNOSTIC CODE - CONTINUED
0008 00
Table 1. Engine Troubleshooting - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
N OT E
19. Intermittent Engine
Shutdown.
Use this procedure only if engine shuts down completely and must be
restarted.
1. Connect MSD and check for active
1. Troubleshoot any active codes before
diagnostic codes using ET software
continuing with this procedure. Refer
to Troubleshooting With a Diagnostic
Code (WP 0009 00).
2. If problem still exists, go to Test 2.
2. Visually check fuel tank for fuel (fuel
1. Add fuel if necessary (TM 5-3805-290-
gage may be faulty).
10).
2. If problem still exists, go to Test 3.
3. Perform Fuel System Pressure Test
If problem still exists, go to Test 4.
4. Perform Fuel Quality Test (WP 0011
If problem still exists, go to Test 5.
5. Perform Air in Fuel System Test (WP
If problem still exists, go to Test 6.
6. Check for fuel supply lines that are
1. Replace or repair any restricted fuel
restricted.
lines (WP 0030 00, WP 0035 00, and
WP 0038 00) and replace fuel filters
(WP 0036 00).
2. If problem still exists, go to Test 7.
1. If solidified fuel is found, drain and fill
7. If temperature is below 32oF (0oC),
tank (WP 0166 00).
check for solidified fuel (wax) in tank.
2. If problem still exists, go to Test 8.
8. Check for correct installation of engine 1. If damaged, replace wiring harness(es)
ECM connectors at these locations
(WP 0169 00 thru WP 0175 00).
(refer to Electrical Connectors
2. If problem still exists, go to Test 9.
Inspection [WP 0022 00]):
(a) J1/P1 engine ECM connector (WP
0053 00).
(b) J20/P20 MIC (WP 0170 00).
(c) J401/P401 speed/timing sensor
connector (WP 0067 00).
(d) J103/P103 inlet manifold
temperature sensor connector (WP
0064 00).
(e) J100/P100 engine coolant
temperature sensor connector (WP
0063 00).
(f) J201/P201 engine oil pressure
sensor connector (WP 0066 00).
