TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
0444 05
427-B1861
N OT E
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear these diagnostic codes when original diagnostic code has
been corrected. Ensure diagnostic code CID 0444 FMI 05 is active before per-
forming this procedure.
1. If diagnostic code remains active, go to
1. Check relay.
Test 2.
(a) Turn battery disconnect switch and
2. If diagnostic code is no longer active,
engine start switch to ON position. Do
relay has failed. Repeat this test to
not start engine (TM 5-3805-290-10).
verify relay failure. Replace relay.
(b) Disconnect start relay from wiring
Verify new relay corrects problem (WP
harness (WP 0054 00).
0054 00).
(c) At relay wiring harness connector,
place a jumper wire from contact 1
(wire 374 PK) to contact 2 (wire H803
BU).
(d) Observe status of CID 0444 FMI 05.