TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
0444 03
427--B1861
427 B1861
N OT E
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear these diagnostic codes when original diagnostic code has
been corrected. Ensure diagnostic code CID 0444 FMI 03 is active before per-
forming this procedure.
1. Check relay energize circuit for a short to
1. If each resistance measurement is
+battery circuit.
greater than 5,000 Ohms, go to Test 2.
(a) Turn engine start switch and battery
2. If each resistance measurement is not
disconnect switch to OFF position (TM
greater than 5,000 Ohms, there is a
short in wiring harness between J2-7
(b) Disconnect wiring harness connector
(374 PK) and circuit that has a low
from start relay (WP 0054 00) and
resistance measurement. Replace
machine ECM (WP 0052 00).
wiring harness in question (WP 0169
(c) At ECM wiring harness connector,
00 thru WP 0175 00).
measure resistance from contact J2-7
(wire 374 PK) to all contacts used in
ECM wiring harness connectors.