TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
0793 03
427-B1874
N OT E
This test procedure may create other diagnostic codes. Ignore these diagnostic
codes and clear diagnostic codes when original diagnostic code has been cor-
rected. Ensure diagnostic code CID 0793 FMI 03 is active before performing this
procedure.
1. Check switch ground circuit in harness.
1. If resistance is less than 5.0 Ohms, go
(a) Turn engine start switch and battery
to Test 2.
disconnect switch to OFF position (TM 2. If resistance is greater than 5,000
Ohms, replace wiring harness in
(b) Disconnect wiring harness
question (WP 0169 00 thru WP 0175
connector(s) from machine ECM (WP
00).
0052 00).
(c) Measure resistance between contact
J1-13 (wire 202 BK) of ECM wiring
harness and contact A (wire 202 BK) at
switch.