TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
0674 02
427-B1872
1. If resistance is greater than 10,000
1. Check sensor case resistance.
Ohms, go to Test 2.
(a) Turn engine start switch and battery
disconnect switch to OFF position (TM 2. If resistance is not greater than 10,000
Ohms, replace transmission
intermediate speed sensor No. 1 (WP
(b) Disconnect wiring harness connector
0069 00).
from transmission intermediate speed
sensor No.1 (WP 0069 00).
(c) Measure resistance from contact 2
(wire E902 PU) and contact 1 (wire
E903 YL) to sensor case.
2. Check sensor resistance.
1. If resistance is approximately 1,075
(a) Wiring harness connector remains
Ohms, go to Test 3.
disconnected.
2. If resistance is not approximately 1,075
(b) Measure resistance between contact 2
Ohms, replace transmission
(wire E902 PU) and contact 1 (wire
intermediate speed sensor No. 1 (WP
E903 YL) of sensor connector.
0069 00).
3. Check for an open wire in wiring harness. 1. If resistance is approximately 1,075
(a) Engine start switch and battery
Ohms, go to Test 4.
disconnect switch remain in OFF
2. If resistance is not approximately 1,075
position (TM 5-3805-290-10).
Ohms, replace wiring harness in
(b) Reconnect wiring harness connector to
question (WP 0169 00 thru WP 0175
sensor.
00).
(c) Disconnect wiring harness
connector(s) from machine ECM (WP
0052 00).
(d) At wiring harness connector, measure
resistance from contact J1-6 (wire
E902 PU) to J1-7 (wire E903 YL).