TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
0675 02
427-B1873
1. Check sensor case resistance.
1. If resistance is greater than 10,000
(a) Turn engine start switch and battery
Ohms, go to Test 2.
disconnect switch to OFF position (TM 2. If resistance is not greater than 10,000
Ohms, replace transmission
(b) Disconnect wiring harness connector
intermediate speed sensor No. 2 (WP
from transmission intermediate speed
0069 00).
sensor No. 2 (WP 0069 00).
(c) Measure resistance from contact 2
(wire E904 BR) and contact 1 (wire
E905 BU) to sensor case.
2. Check sensor resistance.
1. If resistance is approximately 1,075
(a) Wiring harness connector remains
Ohms, go to Test 3.
disconnected.
2. If resistance is not approximately 1,075
(b) Measure resistance between contact 2
Ohms, replace transmission
(wire E904 BR) and contact 1 (wire
intermediate speed sensor No. 2 (WP
E905 BU) of sensor connector.
0069 00).