TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
N OT E
0882 05 -
Cont.
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear these diagnostic codes when original diagnostic code has
been corrected. Ensure diagnostic code CID 882 FMI 05 is active before perform-
ing this procedure.
1. If diagnostic code remains active, go to
1. Check implement lockout solenoid.
Test 2.
(a) Turn battery disconnect switch and
engine start switch to ON position (TM 2. If diagnostic code is no longer active,
implement lockout solenoid has failed.
5-3805-290-10). Do not start engine.
Repeat this test to verify implement
(b) Disconnect implement lockout
lockout solenoid failure. Replace shut-
solenoid from wiring harness (WP
off valve (WP 0188 00). Verify new
0188 00).
implement lockout solenoid corrects
(c) At implement lockout solenoid wiring
problem.
harness connector, place a jumper wire
from contact (wire G962 OR) to
contact (wire H807 YL).
(d) Connect MSD (WP 0006 00) and
observe status of CID 882 FMI 05.
1. If resistance is less than 5.0 Ohms, go
2. Check harness for an open circuit.
to Test 3.
(a) Turn engine start switch and battery
disconnect switch to OFF position (TM 2. If resistance is greater than 5,000
Ohms, replace wiring harness in
question (WP 0169 00 thru WP 0175
(b) Disconnect wiring harness
00).
connector(s) from machine ECM (WP
0052 00).
(c) Jumper wire installed in Test 1 remains
in place.
(d) At wiring harness connector, measure
resistance from signal contact J2-2
(wire G962 OR) to contact J2-4 (wire
H807 YL).
3. Verify diagnostic code remains active.
1. If CID 882 FMI 05 is active, replace
(a) Inspect and clean harness connector
machine ECM (WP 0052 00).
contacts.
2. If CID 882 FMI 05 is not active, initial
(b) Reconnect all harness connectors.
diagnostic code was probably caused
(c) Turn battery disconnect switch and
by a poor electrical connection at a
engine start switch to ON position (TM
harness connector that was
disconnected and reconnected.
(d) Operate machine (TM 5-3805-290-
Resume normal machine operation.
10).
(e) Check status of CID 882 FMI 05.
0009 00-109