TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
2. Verify diagnostic code remains active.
1. If CID 882 FMI 03 is active, replace
0882 03 -
(a) Inspect and clean harness connector
machine ECM (WP 0052 00).
Cont.
contacts.
2. If CID 882 FMI 03 is not active, initial
(b) Reconnect all harness connectors.
diagnostic code was probably caused
(c) Turn battery disconnect switch and
by a poor electrical connection or a
engine start switch to ON position (TM
short at a harness connector that was
disconnected and reconnected.
(d) Operate machine (TM 5-3805-290-
Resume normal machine operation.
10).
(e) Connect MSD (WP 0006 00) and
determine if CID 882 FMI 03 is active.
0882 04
427-B1877
N OT E
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear these diagnostic codes when original diagnostic code has
been corrected. Ensure diagnostic code CID 882 FMI 04 is active before perform-
ing this procedure.
1. Check implement lockout solenoid.
1. If CID 882 FMI 04 changes to CID 882
(a) Turn battery disconnect switch and
FMI 05 when implement lockout
engine start switch to ON position. Do
solenoid is disconnected, implement
not start engine (TM 5-3805-290-10).
lockout solenoid has failed. Repeat this
(b) Connect MSD (WP 0006 00) and
test to verify implement lockout
observe status of diagnostic code.
solenoid failure. Replace shut-off valve
(c) Disconnect implement lockout
(WP 0188 00).
solenoid from wiring harness (WP
2. If CID 882 FMI 04 remains active, go
0188 00).
to Test 2.
