TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
0826 04
427-B1876
1. Check torque converter oil temperature
1. If diagnostic code changed from CID
sensor.
0096 FMI 04 to CID 0096 FMI 03,
(a) Connect MSD (WP 0006 00).
failure is no longer present. Torque
(b) Disconnect wiring harness from torque
converter oil temperature sensor has
converter oil temperature sensor (WP
failed. Replace torque converter oil
0068 00).
temperature sensor (WP 0068 00).
2. If diagnostic code remains, failure
remains present. Torque converter oil
temperature sensor is not causing
failure. Go to Test 2.
2. Check harness.
1. If resistance is greater than 5,000
(a) Torque converter oil temperature
Ohms, replace machine ECM (WP
sensor remains disconnected from
0052 00).
wiring harness.
2. If resistance is less than 5,000 Ohms,
(b) Turn battery disconnect switch and
there is a short between frame ground
engine start switch to OFF position
and signal circuit in wiring harness.
Replace wiring harness in question
(c) Disconnect J1 and J2 wiring harness
(WP 0169 00 thru WP 0175 00).
connectors from machine ECM (WP
0052 00).
(d) At torque converter oil temperature
sensor wiring harness connector,
measure resistance between signal
contact 1 (wire 443 YL) and frame
ground.