TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
2. Check clutch 4 (second speed) solenoid
1. If each resistance measurement is
1404 06 -
energize circuit for a short to ground.
greater than 5,000 Ohms, go to Test 3.
Cont.
(a) Turn engine start switch and battery
2. If each resistance measurement is not
disconnect switch to OFF position (TM
greater than 5,000 Ohms, there is a
short between J1-49 (wire 900 PU) and
(b) Clutch 4 (second speed) solenoid
circuit with low resistance
remains disconnected from wiring
measurement. Replace wiring harness
harness.
in question (WP 0169 00 thru WP 0175
(c) Disconnect wiring harness
00).
connector(s) from machine ECM (WP
0052 00).
(d) At ECM wiring harness connector,
measure resistance from signal contact
J1-49 (wire 900 PU) to all contacts used
in ECM wiring harness connectors.
3. Verify diagnostic code remains active.
1. If CID 1404 FMI 06 is active, replace
(a) Inspect and clean harness connector
machine ECM (WP 0052 00).
contacts.
2. If CID 1404 FMI 06 is not active, initial
(b) Reconnect all harness connectors.
diagnostic code was probably caused
(c) Turn battery disconnect switch and
by a poor electrical connection or a
engine start switch to ON position (TM
short at a harness connector that was
disconnected and reconnected.
(d) Operate machine (TM 5-3805-290-
Resume normal machine operation.
10).
(e) Check status of CID 1404 FMI 06.
0009 00-141