TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
2. Check harness for an open circuit.
1. If resistance is less than 5.0 Ohms, go
1405 05 -
(a) Turn engine start switch and battery
to Test 3.
Cont.
disconnect switch to OFF position (TM 2. If resistance is greater than 5,000
Ohms, there is an open circuit in wire
(b) Disconnect wiring harness
901 WH or wire 975 WH of wiring
connector(s) from machine ECM (WP
harness. Replace wiring harness in
0052 00).
question (WP 0169 00 thru WP 0175
(c) Jumper wire installed in Test 1 remains
00).
in place.
(d) At wiring harness connector, measure
resistance from signal contact J1-51
(wire 901 WH) to contact J1-50 (wire
975 WH).
3. Verify diagnostic code remains active.
1. If CID 1405 FMI 05 is active, replace
(a) Inspect and clean harness connector
machine ECM (WP 0052 00).
contacts.
2. If CID 1405 FMI 05 is not active, initial
(b) Reconnect all harness connectors.
diagnostic code was probably caused
(c) Turn battery disconnect switch and
by a poor electrical connection at a
engine start switch to ON position (TM
harness connector that was
disconnected and reconnected.
(d) Operate machine (TM 5-3805-290-
Resume normal machine operation.
10).
(e) Check status of CID 1405 FMI 05.
0009 00-145