TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
1405 06
427-B1884
N OT E
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear these diagnostic codes when original diagnostic code has
been corrected. Ensure diagnostic code CID 1405 FMI 06 is active before per-
forming this procedure.
1. Check clutch 5 (third and fourth speed)
1. If CID 1405 FMI 06 changes to CID
solenoid.
1405 FMI 05 when clutch 5 (third and
(a) Turn battery disconnect switch and
fourth speed) solenoid is disconnected,
engine start switch to ON position (TM
clutch 5 (third and fourth speed)
5-3805-290-10). Do not start engine.
solenoid has failed. Repeat this test to
(b) Connect MSD (WP 0006 00) and
verify clutch 5 (third and fourth speed)
observe status of diagnostic code.
solenoid failure. Replace modulating
(c) Disconnect clutch 5 (third and fourth
valve (WP 0177 00).
speed) solenoid with active diagnostic 2. If CID 1405 FMI 06, go to Test 2.
code from wiring harness (WP 0177
00).