TM 5-3805-290-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 2. Machine Control System - Continued.
(MID 081)
TEST OR INSPECTION
CORRECTIVE ACTION
CID FMI CODE
1405 03
427-B1884
N OT E
This test procedure may create other diagnostic codes. Ignore these created diag-
nostic codes and clear these diagnostic codes when original diagnostic code has
been corrected. Ensure diagnostic code CID 1405 FMI 03 is active before per-
forming this procedure.
1. Check clutch 5 (third and fourth speed)
1. If each resistance measurement is
solenoid energize circuit for a short to
greater than 5,000 Ohms, go to Test 2.
+battery circuit.
2. If each resistance measurement is not
(a) Turn engine start switch and battery
greater than 5,000 Ohms, there is a
disconnect switch to OFF position (TM
short between J1-51 (901 WH) and
circuit that has lowest resistance
(b) Disconnect wiring harness connectors
measurement. Replace wiring harness
from clutch 5 (third and fourth speed)
in question (WP 0169 00 thru WP 0175
solenoid (WP 0177 00) and machine
00).
ECM (WP 0052 00).
(c) At ECM wiring harness connector,
measure resistance from contact J1-51
(wire 901 WH) to all contacts used in
ECM wiring harness connectors.