TM 5-3805-290-23-1
STEERING SYSTEM TESTS, INSPECTIONS, AND ADJUSTMENTS - CONTINUED
0016 00
PISTON PUMP (STEERING AND PILOT) HIGH PRESSURE
STALL TEST AND ADJUSTMENT - CONTINUED
N OT E
Pressure compensator valve is located at
top of steering piston pump.
20.
If pressure readings are correct, proceed to step 26. If
pressure readings are not correct, pressure compensa-
tor valve (3) needs to be adjusted. To adjust pressure
compensator valve, proceed to step 21.
427-B0950
21.
Remove chassis cover from left side of machine (WP 0107 00).
22.
Loosen locknut (4).
N OT E
When decreasing pressure setting, turn
adjusting screw counterclockwise below
needed pressure. Then turn adjusting
screw clockwise to correct pressure set-
ting. This method of adjusting pressure
setting eliminates any free play in threads.
23.
Adjust pressure as needed. Turn adjusting screw (5)
clockwise to increase pressure. Turn adjusting screw
counterclockwise to decrease pressure. Adjusting
screw is 0.12 in. (3 mm).
24.
Tighten locknut (4).
427-B0951
0016 00-4