TM 5-3805-290-23-1
STEERING SYSTEM TESTS, INSPECTIONS, AND ADJUSTMENTS - CONTINUED
0016 00
METERING PUMP (HMU) TEST - CONTINUED
7.
Connect Nipple, pipe (Item 49, WP 0205 00) to one end of Hose (Item 38, WP 0205 00).
8.
Connect Coupling, hose (Item 26, WP 0205 00) to other end of Hose (Item 38, WP 0205 00).
9.
Install Coupling, hose (Item 26, WP 0205 00) on test stand.
10.
Install Nipple, pipe (Item 49, WP 0205 00) into Coupling, hose (Item 27, WP 0205 00).
11.
Install Coupling, hose (Item 27, WP 0205 00) on Coupling half, quick disconnect (Item 28, WP 0205 00).
12.
Start machine (TM 5-3805-290-10). Raise work tool off ground. Disengage parking brake. Run machine at high idle.
13.
Repeatedly turn machine from left steering stop to right steering stop. Observe pressure gage. Pressure on gage should
not register above 150 psi (1,034 kPa).
14.
Straighten machine. Lower work tool to ground. Reduce speed to low idle. Engage parking brake.
15.
Stop machine (TM 5-3805-290-10).
16.
If pressure was above 150 psi (1,034 kPa), replace metering pump (WP 0101 00).
END OF WORK PACKAGE
0016 00-12