TM 5-3805-290-23-2
FUEL INJECTOR LINES REPLACEMENT - CONTINUED
0030 00
CLEANING AND INSPECTION
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low-toxic material.
However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in well-ventilated
areas. Keep away from open flames and other sources of ignition. Failure to do so may result in injury or
death to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure when dry-
ing parts with compressed air. DO NOT direct compressed air against human skin. Make sure air stream is
directed away from user and other personnel in the area. To prevent injury, user must wear protective goggles
or face shield. Failure to follow this warning may result in injury to personnel.
1.
Clean all parts and surfaces with solvent cleaning compound.
2.
Dry parts with compressed air.
3.
Inspect all parts for wear, pitting, cracks, or corrosion and replace if necessary.
INSTALLATION
1.
Position six fuel injector lines (1) on machine.
2.
Connect six fuel injector lines (1) to fuel injection pump (3). Tighten fuel injector lines to 20 lb-ft (27 Nm).
3.
Connect six fuel injector lines (1) to fuel injectors (2). Tighten fuel injector lines to 20 lb-ft (27 Nm).
4.
Install muffler and support bracket (WP 0041 00).
5.
Connect two fuel filter lines to top of fuel injection pump (WP 0038 00).
6.
Connect two lines to fan and brake hydraulic pump (WP 0186 00).
7.
Prime fuel system (WP 0029 00).
8.
Run engine to check for leaks and verify correct operation (TM 5-3805-290-10).
9.
Shut down engine (TM 5-3805-290-10).
10.
Check for fuel system leaks.
END OF WORK PACKAGE
0030 00-3/(0030 00-4 Blank)
