TM 5-3805-290-23-2
RIDE CONTROL PRESSURE SWITCH REPLACEMENT - CONTINUED
0073 00
REMOVAL
1.
Disconnect wiring harness (1) from ride control pres-
sure switch (2).
2.
Remove ride control pressure switch (2) and O-ring
(3) from elbow (4). Discard O-ring.
INSTALLATION
1.
Lubricate new O-ring (3) with thin coat of clean oil,
install O-ring on ride control pressure switch (2), and
install assembly in elbow (4). Tighten switch to 26 2
lb-ft (35 3 Nm).
2.
Connect wiring harness (1) to ride control pressure
switch (2).
427-B0194
3.
Check oil level and fill hydraulic tank with oil if necessary (WP 0137 00).
4.
Run engine until normal operating temperature is reached (TM 5-3805-290-10).
5.
Operate machine using ride control (TM 5-3805-290-10).
6.
Shut down engine (TM 5-3805-290-10).
7.
Check for hydraulic oil leaks.
8.
END OF WORK PACKAGE
0073 00-2