4
TM 5-3805-290-23-2
COMBINATION VALVE REPLACEMENT
THIS WORK PACKAGE COVERS
Removal, Cleaning and Inspection, Installation
INITIAL SETUP
Maintenance Level
Materials/Parts - Continued
Rag, wiping (Item 41, WP 0206 00)
Unit
Tag, marker (Item 54, WP 0206 00)
Tools and Special Tools
O-ring (8)
Tool kit, general mechanic's (Item 96, WP 0205 00)
Personnel Required
Shop equipment, common no. 1 (Item 77, WP 0205
MOS 62B, Construction Equipment Repairer
References
Materials/Parts
TM 5-3805-290-10
Cap set, protective (Item 8, WP 0206 00)
Equipment Conditions
Cleaning compound, solvent, type III (Item 9, WP
Right-side chassis covers removed (WP 0107 00)
Hydraulic tank drained (WP 0140 00)
Oil, lubricating, OEA-30, Arctic (Item 32, WP
Drawings Required
Oil, lubricating, OE/HDO-5/40 (Item 34, WP 0206
TM 5-3805-290-23P, Figure 126
Estimated Time to Complete Task
Oil, lubricating, OE/HDO-15/40 (Item 35, WP
3.0 hr
WARN I N G
When servicing this machine, performing maintenance, or disposing of hazardous materials, consult your
unit/local hazardous waste disposal center or safety office for local regulatory guidance. If further informa-
tion is needed, please contact The Army Environmental Hotline at 1-800-872-3845.
DO NOT disconnect or remove any hydraulic system line or fitting unless engine is shut down and hydraulic
system pressure has been relieved. Tighten all connections before applying pressure. Escaping hydraulic fluid
under pressure can penetrate the skin, causing injury to personnel.
At operating temperature, hydraulic oil is hot. Allow hydraulic oil to cool before disconnecting any hydraulic
lines. Failure to follow this warning may result in injury to personnel.
Lubricating/hydraulic oils used in the performance of maintenance can be very slippery. Immediately wipe up
any spills. Failure to follow this warning may result in injury to personnel.
To prevent injury to personnel, wear protective eye covering and gloves.
C AU T I O N
Wipe area clean around all connections to be opened during removal. Cap lines and hoses and plug
openings after removing lines. Contamination of system could result in premature failure.