TM 5-3805-290-23-2
ROCKER ARMS AND PUSH RODS MAINTENANCE - CONTINUED
0156 00
ASSEMBLY
WARN I N G
Spring is under tension. Wear eye protection and use extreme caution when removing spring to avoid
injury to personnel.
N OT E
Ensure that all oil holes in rocker shaft and in rocker arms are NOT plugged before you begin assem-
bly procedure. Lubricate all components with clean engine oil before assembly.
1.
Install retaining ring (7) and two washers (8) on one end of rocker shaft assembly (3). Tighten retaining ring to 35 lb-in.
(4 Nm).
N OT E
Clearance between rocker arm bushing and rocker shaft is 0.001 to 0.004 in. (0.03 to 0.09 mm).
2.
Install 12 rocker arm assemblies (9), bushings (10),
six shaft brackets (11), and springs (12) on rocker
shaft assembly (3).
3.
Install retaining ring (7) and two washers (8) on other
end of rocker shaft assembly (3). Tighten retaining
ring to 35 lb-ft (4 Nm).
427-B0516
INSTALLATION
1.
Install 12 pushrods (6) in engine.
427-B0514
0156 00-4