TM 5-3805-291-10
DESCRIPTION AND USE OF OPERATOR CONTROLS AND INDICATORS - CONTINUED
0004 00
MONITORING SYSTEM - CONTINUED
0004 00
Front Dash Indicators - Continued
WAR N I N G
Do not operate the machine until the steering fault has been corrected. Failure to follow this warning
may cause injury or death to personnel.
N OT E
Secondary steering only works while the machine is moving. Directional changes can be made when
the machine operates under secondary steering.
Secondary Steering (10). This indicator illuminates when the secondary steering is functioning. When you turn the
3.
engine start switch to the ON position, the alert indicator for the secondary steering will come on for 3 seconds. Then,
the alert indicator will go off. If the alert indicator for the secondary steering does not come on, investigate the cause of
the fault. Refer to Troubleshooting Introduction (WP 0008 00). Do not operate the machine until the fault has been cor-
rected.
Transmission Neutralizer (11). This indicator illuminates when the transmission neutralizer is deactivated.
4.
5.
Transmission Failure (12). This indicator illuminates when a serious problem exists in the electronic system of the
transmission. Immediately stop the machine. Stop the engine. Investigate the cause. Refer to Troubleshooting Introduc-
tion (WP 0008 00).
Parking Brake (13). This indicator illuminates when the parking brake is engaged. The indicator should flash during
6.
start-up.
Ride Control (14). This indicator illuminates when the ride control is activated.
7.
8.
Action Light (15). This indicator illuminates when a fault has been detected by the monitoring system. Refer to Trou-
bleshooting Introduction (WP 0008 00).
427-C0477
0004 00-24
