TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(b) Connect one end of a jumper wire to
0795 07 - Continued.
contact C2 at relay.
(c) Connect other end from jumper wire to
frame ground.
(d) Turn engine start switch to ON
1. If, during self-test, indicator for
position. During self-test for secondary
secondary steering system illuminates,
steering system, monitor indicator for
go to Test 10.
secondary steering system (TM 5-
2. If, during self-test, indicator for
3805-291-10).
secondary steering system does not
illuminate, replace secondary steering
relay (WP 0053 00).
10.Check circuit from ECM to relay.
(a) Turn engine start switch to OFF
position (TM 5-3805-291-10).
(b) Use contact removal tool to remove
wire K748-OR from contact J2-9 at
powertrain ECM.
(c) Using a jumper wire, connect wire
K748-OR to frame ground.
(d) Turn engine start switch to ON
1. If, during self-test, indicator for
position. During self-test for secondary
secondary steering system illuminates,
steering system, monitor indicator for
exit this procedure and repeat this
secondary steering system (TM 5-
procedure. If cause of problem is still
3805-291-10).
not found, replace powertrain ECM
(WP 0063 00).
2. If, during self-test, indicator for
secondary steering system does not
illuminate, wire K748-OR has failed.
Replace wiring harness in question (WP
0195 00 thru WP 0201 00).
0009 00-94
