TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1. If resistance is less than 5 Ohms, go to
(c) Measure the resistance to frame
0795 07 - Continued.
ground.
Test 7.
2. If resistance is over 5 Ohms, ground
circuit for relay has failed. Replace
wiring harness in question (WP 0195 00
thru WP 0201 00).
7. Check signal wire between two relays.
(a) At relay by secondary steering motor,
connect one lead from multimeter to
signal wire (727-GN).
(b) Connect other lead from multimeter to
the secondary steering intermediate
relay (contact 4).
(c) Measure resistance between two
1. If resistance is less than 5 Ohms, go to
relays.
Test 8.
2. If resistance is over 5 Ohms, circuit has
failed. Replace wiring harness in
question (WP 0195 00 thru WP 0201
00).
8. Check +battery circuit at secondary steering
relay.
(a) Reconnect wiring harness connector to
connector J2 of powertrain ECM (WP
0063 00).
(b) Turn battery disconnect and engine
start switches to ON position (TM 5-
3805-291-10).
(c) At secondary steering relay, connect
one lead from multimeter to contact 1
(wire 136-GN).
(d) Measure voltage from contact 1 to
1. If voltage measurement is equal to
frame ground. Note voltage.
system voltage, go to Test 9.
2. If voltage measurement is not equal to
system voltage, power circuit to relay
has failed. Replace wiring harness in
question (WP 0195 00 thru WP 0201
00).
9. Check circuit from ECM to relay.
(a) Turn engine start switch to OFF
position (TM 5-3805-291-10).
0009 00-93