TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2. Check if diagnostic code is still active
1400 03 - Continued.
(a) Inspect and clean wiring harness
connector contacts.
(b) Reconnect wiring harness connector.
(c) Operate machine (TM 5-3805-291-
10).
(d) Use messenger to determine if CID
1. If CID 1400 FMI 03 is active, exit this
1400 FMI 03 is active (TM 5-3805-
procedure and repeat this procedure. If
291-10).
cause of diagnostic code is not found,
replace the powertrain ECM (WP 0063
00).
2. If CID 1400 FMI 03 is not active,
problem does not exist at this time.
Resume normal machine operation.
N OT E
1400 06
The following procedure may create other diagnostic codes. Ignore these
created diagnostic codes and clear these diagnostic codes when original
diagnostic code is corrected. Ensure diagnostic code CID 1400 FMI 06 is
active before performing this procedure.
1. Check relay energizer circuit for a short to
ground.
(a) Turn engine start and battery
disconnect switches to OFF position
(TM 5-3805-291-10).
(b) Relay remains disconnected from
wiring harness.
(c) Disconnect wiring harness
connector(s) from powertrain ECM
(WP 0063 00).
(d) At wiring harness connector, measure
1. If each resistance measurement is
resistance from signal contact J2-2
greater than 5,000 Ohms, go to Test 2.
(wire J887-PU) to all contacts used in
2. If each resistance measurement is not
wiring harness connectors for the
greater than 5,000 Ohms, short is
ECM.
between J2-2 (J887-PU) and circuit with
low resistance measurement. Replace
wiring harness in question (WP 0195 00
thru WP 0201 00).
2. Check if diagnostic code remains active.
(a) Inspect and clean wiring harness
connector contacts.
