TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1. If diagnostic code remains active, go to
(d) Use messenger to check status of CID
1401 05 - Continued.
1401 FMI 05 (TM 5-3805-291-10).
Test 2.
2. If diagnostic is not active, repeat Test 1
to verify solenoid failure. Replace
modulating valve with active code (WP
0203 00). Verify new solenoid corrects
problem.
2. Check wiring harness for an open circuit.
(a) Turn engine start and battery
disconnect switches to OFF position
(TM 5-3805-291-10).
(b) Disconnect wiring harness
connector(s) from powertrain ECM
(WP 0063 00).
(c) Jumper wire installed in Test 1 remains
in place.
(d) At wiring harness connector, measure
1. If resistance is less than 5.0 Ohms, go to
resistance from signal contact J1-17
Test 3.
(wire 751-GN) to contact J1-55 (wire
2. If resistance is greater than 5,000 Ohms,
J808-BK).
open circuit is in wire 751-GN or in wire
J808-BK of wiring harness. Replace
wiring harness in question (WP 0195 00
thru WP 0201 00).
3. Check if diagnostic code remains active.
(a) Inspect and clean wiring harness
connector contacts.
(b) Reconnect all wiring harness
connectors.
(c) Operate machine (TM 5-3805-291-
10).
(d) Use messenger to check status of CID
1. If CID 1401 FMI 05 is active, exit this
1401 FMI 05 (TM 5-3805-291-10).
procedure and repeat this procedure. If
cause of diagnostic code is not found,
replace powertrain ECM (WP 0063 00).
2. If CID 1401 FMI 05 is not active,
diagnostic code does not exist at this
time. Resume normal machine
operation.
0009 00-112
