TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
(b) Reconnect wiring harness connectors.
1400 06 - Continued.
(c) Operate machine (TM 5-3805-291-
10).
(d) Use messenger to check status of CID
1. If CID 1400 FMI 06 is active, exit this
1400 FMI 06 (TM 5-3805-291-10).
procedure and repeat this procedure. If
cause of diagnostic code is not found,
replace powertrain ECM (WP 0063 00).
2. If CID 1400 FMI 06 is not active,
diagnostic code does not exist at this
time. Resume normal machine
operation.
1401 03
427-C1634
N OT E
The following procedure may create other diagnostic codes. Ignore these
created diagnostic codes and clear these diagnostic codes when original
diagnostic code is corrected. Ensure diagnostic code CID 1401 FMI 03 is
active before performing this procedure.
1. Check solenoid energizer circuit for a short
to +battery circuit.
(a) Turn engine start and battery
disconnect switches to OFF position
(TM 5-3805-291-10).
(b) Disconnect wiring harness
connector(s) from clutch solenoid and
powertrain ECM (WP 0056 00, WP
0057 00, WP 0060 00, and WP 0063
00).
(c) At wiring harness connector for ECM,
1. If each resistance measurement is
measure resistance from contact J1-65
greater than 5 Ohms, go to Test 2.
(wire 751-GN) to all possible sources
2. If each resistance measurement is not
of +battery.
greater than 5 Ohms, short is between
J1-65 (wire 751-GN) and +battery
circuit. Replace wiring harness in
question (WP 0195 00 thru WP 0201
00).
