TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
2. Check wiring harness for open circuit.
1402 05 - Continued.
(a) Turn engine start and battery
disconnect switches to OFF position
(TM 5-3805-291-10).
(b) Disconnect wiring harness
connector(s) from powertrain ECM
(WP 0063 00).
(c) Jumper wire installed in Test 1 remains
in place.
1. If resistance is less than 5.0 Ohms, go to
(d) At wiring harness connector, measure
Test 3.
resistance from signal contact J1-62
(wire 752-YL) to contact J1-60 (wire
2. If resistance is greater than 5,000 Ohms,
J809-BK).
open circuit is in wire 752-YL or in wire
J809-BK of wiring harness. Replace
wiring harness in question (WP 0195 00
thru WP 0201 00).
3. Check if diagnostic code remains active.
(a) Inspect and clean wiring harness
connector contacts.
(b) Reconnect all wiring harness
connectors.
(c) Operate machine (TM 5-3805-291-
10).
(d) Use messenger to check status of CID
1. If CID 1402 FMI 05 is active, exit this
1402 FMI 05 (TM 5-3805-291-10).
procedure and repeat this procedure. If
cause of the diagnostic code is not
found, replace powertrain ECM (WP
0063 00).
2. If CID 1402 FMI 05 is not active,
diagnostic code does not exist at this
time. Resume normal machine
operation.
0009 00-117
