TM 5-3805-291-23-1
TROUBLESHOOTING WITH A DIAGNOSTIC CODE - CONTINUED
0009 00
Table 3. Powertrain Control - Continued.
(MID 081)
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
1402 06
427-C1635
N OT E
The following test procedure may create other diagnostic codes. Ignore
these created diagnostic codes and clear these diagnostic codes when
original diagnostic code is corrected. Ensure diagnostic code CID 1402
FMI 06 is active before performing this procedure.
1. Check solenoid.
(a) Turn battery disconnect and engine
start switches to ON position. Do not
start engine (TM 5-3805-291-10).
(b) Connect MSD (WP 0005 00) and
observe status of diagnostic code.
(c) Disconnect solenoid with active
1. If diagnostic code remains active, go to
diagnostic code from wiring harness
Test 2.
(WP 0203 00).
2. If diagnostic code is no longer active,
repeat this test in order to verify
solenoid failure. Replace modulating
valve with active code (WP 0203 00).
Verify new solenoid corrects problem.
2. Check solenoid energizer circuit for a short
to ground.
(a) Turn engine start and battery
disconnect switches to OFF position
(TM 5-3805-291-10).
(b) Solenoid remains disconnected from
wiring harness.
(c) Disconnect wiring harness
connector(s) from powertrain ECM
(WP 0063 00).