TM 5-3805-291-23-2
CENTER DRIVE SHAFT (SLIP JOINT) REPLACEMENT - CONTINUED
0107 00
INSTALLATION
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Ensure that any lifting equipment used is in good condition and of suitable load capacity. Keep
clear of heavy parts supported only by lifting equipment. Failure to follow this warning may result in injury
or death to personnel.
N OT E
Center drive shaft weighs 60 lb (27 kg).
Align index marks on drive shaft and U-joint.
1.
Use lifting equipment to support center driveshaft.
2.
With assistance, position center drive shaft (3) on machine and install two straps (2) and four bolts (1) to both ends of
center drive shaft. Tighten bolts to 111 11 lb-ft (150 15 Nm).
WAR N I N G
Before operating the machine, secure the steering frame lock in the stowed position. DO NOT operate
machine with steering frame lock connected. Failure to lock steering frame lock into the stowed posi-
tion before operating can result in loss of steering and injury or death to personnel.
3.
Secure steering frame lock in stowed position (TM 5-3805-291-10).
N OT E
Lubricate all grease fittings with multipurpose grease.
Lubricate splines with molybden m or multipurpose grease.
u
4.
Lubricate center drive shaft (3).
5.
Drive machine and verify correct operation of center drive shaft (TM 5-3805-291-10).
END OF WORK PACKAGE
0107 00-3/(0107 00-4 Blank)
