TM 5-3805-291-23-2
FRONT DRIVE SHAFT REPLACEMENT - CONTINUED
0109 00
INSTALLATION
WARN I N G
Use extreme caution when handling heavy parts. Provide adequate support and use assistance during pro-
cedure. Failure to follow this warning may result in injury to personnel.
CAU T I ON
The front drive shaft must be installed in phase with the front axle assembly yoke, and the center and
rear drive shafts. If it is not, serious component damage could occur. Ensure all joint groups, yokes,
and lubricating fittings are aligned.
N OT E
Front drive shaft weighs 40 lb (18 kg).
Lubricate all grease fittings with multipurpose grease.
Splines should be lubricated with molybdenum or multipurpose grease with machine fully articu-
lated.
1.
Using lifting equipment, carefully position front drive shaft (1) on machine.
2.
With assistance, position front drive shaft (1) on yoke (4) and install two collars (3) and four bolts (2) on front drive
shaft. Tighten bolts to 125 11 lb-ft (170 15 Nm).
3.
Install carrier bearing (WP 0108 00).
4.
Drive machine and verify correct operation of front drive shaft (TM 5-3805-291-10).
END OF WORK PACKAGE
0109 00-3/(0109 00-4 Blank)
