TM 5-3805-291-23-2
REAR DRIVE SHAFT REPLACEMENT - CONTINUED
0110 00
INSTALLATION
C AU T I O N
The rear drive shaft must be installed in phase with the rear axle assembly yoke and the center and
front drive shafts. If it is not, serious component damage could occur. Ensure all joint groups, yokes,
and lubricating fittings are aligned.
1.
Slide yoke (4) toward rear axle assembly to provide
enough clearance for rear drive shaft (1) installation.
2.
Carefully install rear drive shaft (1) on machine.
3.
Slide yoke (4) toward rear drive shaft (1) so rear drive
shaft is properly located.
4.
Support rear drive shaft (1) and install four straps (3)
and eight bolts (2) on rear drive shaft. Tighten bolts to
110 11 lb-ft (150 15 Nm).
N OT E
Lubricate all grease fittings with
multipurpose grease.
Lubricate splines with molybdenum
427-C0453
or multipurpose grease with
machine fully articulated.
5.
Lubricate rear drive shaft (1).
6.
Drive machine and verify correct operation of rear drive shaft (TM 5-3805-291-10).
END OF WORK PACKAGE
0110 00-3/(0110 00-4 Blank)