TM 5-3805-291-23-2
PARKING BRAKE ACTUATOR REPLACEMENT - CONTINUED
0112 00
N OT E
Tag hoses prior to removal to ensure correct installation.
Use a container to catch any fluid that may drainfrom hoses or system. Dispose of fluid IAW local
policy and ordinances. Ensure all spills are cleaned up.
Parking brake actuator is located inside loader frame.
REMOVAL
1.
Disconnect hose (1) and remove O-ring (2) from park-
ing brake actuator (3). Discard O-ring.
2.
Remove clevis (4) and cotter pin (5) from yoke assem-
bly (6). Discard cotter pin.
3.
Disconnect yoke assembly (6) from parking brake
actuator lever (7).
4.
Remove two nuts (8) and washers (9) from parking
brake actuator (3).
5.
Remove parking brake actuator (3) from machine.
427-C0119
CLEANING AND INSPECTION
WARN I N G
Solvent cleaning compound MIL-PRF-680 Type III is an environmentally compliant and low-toxic
material. However, it may be irritating to the eyes and skin. Use protective gloves and goggles. Use in
well-ventilated areas. Keep away from open flames and other sources of ignition. Failure to do so may
result in injury or death to personnel.
Particles blown by compressed air are hazardous. DO NOT exceed 15 psi (103 kPa) nozzle pressure
when drying parts with compressed air. DO NOT direct compressed air against human skin. Make
sure air stream is directed away from user and other personnel in the area. To prevent injury, user
must wear protective goggles or face shield. Failure to follow this warning may result in injury to per-
sonnel.
1.
Clean all parts and mating surfaces with solvent cleaning compound.
2.
Dry parts with compressed air.
3.
Inspect all parts for wear, pitting, cracks, or corrosion and replace if necessary.
0112 00-2
