TM 5-3805-291-23-2
FLYWHEEL HOUSING REPLACEMENT - CONTINUED
0176 00
INSPECTION
N OT E
Flywheel inspection is in WP 0177 00.
Face Runout (Axial Eccentricity)
1.
Attach dial indicator to flywheel (7) so anvil of dial indicator contacts face of flywheel housing (1).
2.
Use rubber mallet and tap crankshaft toward rear before dial indicator is read at each point.
3.
Turn flywheel (7) while dial indicator is set at 0.00 in. (0.0 mm) at location (A).
4.
Read dial indicator at locations (B, C, and D).
5.
Difference between lower measurements and higher measurements at all four points must not be more than 0.015 in.
(0.38 mm), which is maximum permissible face runout (axial eccentricity) of flywheel housing.
427-C0561
427-C0560
Bore Runout (Radial Eccentricity)
1.
Attach dial indicator to flywheel (7) so anvil of dial
indicator contacts bore of flywheel housing (1).
2.
While dial indicator is in position at location (C),
adjust dial indicator to 0.00 in. (0.0 mm).
3.
Push crankshaft upward against top of bearing.
4.
Write measurements for bearing clearance on line 1 in
column (C) of chart.
427-C0562
0176 00-4
