TM 5-3805-292-23
0086
DISASSEMBLY
00086
1. Remove screw (Figure 5, Item 2) from cylinder head (Figure 5, Item 1).
Figure 5. Lift Cylinder.
0086
WARN I N G
Oil is very slippery. Immediately wipe up any spills. Failure to follow this warning may
cause injury to personnel.
2. Compress piston rod (Figure 6, Item 13). Drain oil from cylinder into container.
3. Loosen cylinder head (Figure 6, Item 7) from lift cylinder (Figure 6, Item 1) and pull piston rod (Figure 6, Item
13) straight out of lift cylinder.
4. Place a padded support below piston rod (Figure 6, Item 13) near piston (Figure 6, Item 11) to prevent damage
to piston rod.
5. Remove nut (Figure 6, Item 12), piston (Figure 6, Item 11), and cylinder head (Figure 6, Item 7) from piston rod
(Figure 6, Item 13).
6. Remove seal (Figure 6, Item 9) and wear ring (Figure 6, Item 10) from piston (Figure 6, Item 11). Discard seal
and wear ring.
7. Remove O-ring (Figure 6, Item 8), washer (Figure 6, Item 3), three seals (Figure 6, Item 4, 5, and 6), from cyl-
inder head (Figure 6, Item 7). Discard seals and O-ring.
8. Remove two fittings (Figure 6, Item 2) from lift cylinder (Figure 6, Item 1).
