TM 5-3805-292-23
0148
REMOVAL
000148
1. Disconnect wiring harness (Figure 1, Item 2) from sensor (Figure 1, Item 1) and remove sensor from machine.
2. Remove and discard O-ring (Figure 1, Item 3).
Figure 1. Engine Oil Pressure Sensor.
0148
END OF TASK
INSTALLATION
000148
WARN I N G
Use caution when using adhesives and sealants. Prolonged inhalation of vapors can
cause lung irritation. Contact with skin can cause dermatitis. Wear gloves and safety
goggles and use product in a well-ventilated area away from open flame. If ingested, keep
individual calm and seek medical attention. DO NOT induce vomiting. If contact with skin
or eyes is made, flush thoroughly with water. Dispose of cleanup rags IAW local policy and
ordinances. Failure to follow this warning may cause injury to personnel.
1. Apply sealing compound to sensor (Figure 1, Item 1).
N OT E
Lubricate O-ring with engine oil before installation.
2. Install new O-ring (Figure 1, Item 3) and sensor (Figure 1, Item 1) on machine and connect wiring harness (Fig-
ure 1, Item 2) to sensor.
END OF TASK