TM 5-3805-298-23-1
0097
Table 1. 600 Hydraulic Oil Temperature Sensor Diagnostic Codes - Continued.
097
CID FMI CODE
TEST OR INSPECTION
CORRECTIVE ACTION
3. Disconnect connector EN-C18
600-3 Hydraulic Oil
(WP 0012, Figure 73) from
Temperature Sensor Voltage
hydraulic oil temperature sensor.
Is Above Normal or Shorted
High - Continued
4. Turn battery disconnect switch and
ignition switch to ON position
(TM 5-3805-298-10).
5. Using digital multimeter
Voltage 4.5 to 8V - Replace hydraulic
(WP 0174), test for voltage
oil temperature sensor
between connector EN-C18
(WP 0243).
WP 0012, Figure 73) terminal 1
Proceed to Test Step 8.
and 2 (ground).
Voltage Not 4.5 to 8V - Proceed to Test
Step 3.
Test Step 3. Test for Open Wiring
Harness.
1. Turn ignition switch and battery
disconnect switch to OFF position
(TM 5-3805-298-10).
2. Install a jumper wire between
terminal 1 and terminal 2 of
connector EN-C18 (WP 0012,
Figure 73).
3. Remove left lower cab access
panels (WP 0347).
4. Remove transmission ECM cover
(WP 0266).
5. Disconnect connector C-C12
(WP 0012, Figure 26) from
Transmission ECM J1.
6. Using digital multimeter
Resistance 5.0 Ohms or Less -
(WP 0174), measure resistance
Proceed to Test Step 6.
between connector C-C12
Resistance Greater Than 5.0 Ohms -
(WP 0012, Figure 26) terminal 30
Proceed to Test Step 4.
and terminal 23.
Test Step 4. Test for Open Engine
Wiring Harness.
1. Remove right lower cab access
panels (WP 0347).
2. Disconnect connector EN-C8
(WP 0012, Figure 22) from
connector C-C19 (WP 0012,
Figure 23).
3. Disconnect connector EN-C2
(WP 0012, Figure 12) from
connector C-C18 (WP 0012,
Figure 13).
0097-3